LG HB6422BGF Instrukcja Użytkownika

Installation and Operating InstructionsBuilt-In Gas Cooktops HB6422BRUP/No.: MFL62060313www.lg.comTo avoid the risk of accidents or damage to the Gas

5. ADAPTATION TO DIFFERENT TYPES OF GASBefore performing any cleaning or maintenance work, detach the appliance from the electrical socket.The hob has

5.2 Regulation for LPGLoosen screw A and push support B all the way. Use a double head wrench to remove nozzle C and assemble the suitable one, follow

Instructions for the installer5.3 Regulation for natural gasThe hob has been inspected for G20 (2H) natural gas at a pressure of 20 mbar. To allow the

6. Final operationsHaving carried out the above adjustments, reassemble the appliance following, backwards, the instructions in paragraph “5.1 Removin

Instructions for the installer6.3 Arrangement of burners on hob6.4 Lubrication of gas tapsAfter a while, the gas tap may become hard to turn or lock.

7. Using the hobBefore turning on the burners, make sure that the burner rings, caps and grids have been fitted correctly.In the Wok burner, notch A m

Instructions for the user7.2 Practical advice for using the burnersFor better burner performance and minimum gas consumption, flat bottomed, even reci

178. Cleaning and maintenanceNever use a steam jet to clean the appliance.Before any intervention, disconnect the power supply of the device.8.1 Clean

188.2 Cleaning of cooking hob componentsCAUTION: do not wash these components in a dishwasher. In normal use of the hob, the stainless steel burner ca

Contents2Introduction ... 31. Instructions for safe and proper use ...

Printed in Italy

3Introduction1. Instructions for safe and proper useThis manual is an integral part of the appliance and therefore must be kept in its entirety and in

IntroductionThe identification plate, with technical data, serial number and marking is clearly visible under the casing.The plate on the casing must

5Instructions for the installer2. POSITIONING OF HOBThe following operation requires building and/or carpentry work so must be carried out by a compet

Instructions for the installerAccurately position the gasket provided all around the outer edge of the hole in the top surface as shown in the figures

73. Electrical connectionMake sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do

Instructions for the installer4. GAS CONNECTIONConnection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and conforming

94.1 Connection to LPG Use a pressure regulator and make the connection to the tank according to the provisions of standards regulations in force. Ma